beautypg.com

Installation – Microsens MS400934 User Manual

Page 7

background image

5

Installation

To install the Power over Ethernet Injector, please follow the steps below:

1. Connect one end of the RJ-45 cable to the Switch/HUB and connect

the other end to the Data in port on the Power over Ethernet Injector.

2. Connect the RJ-45 cable between the Data out port of the injector and

the PoE Splitter, PD (Such as Router, Access Point

…etc.) or PoE Hub.

3. Plug in the power cord of the Power over Ethernet Injector to the wall

power plug.

4. Before starting, make sure all connections are correct:

 The Power over Ethernet Injector connects to the Splitter, POE

Hub or PD via Data Out port.

 The Power over Ethernet Injector connects to the switch via Data

In port.

 The AC In connector is to get the power supply to Power over

Ethernet Injector from wall power plug.