Package contents, Installation – Microsens MS400930 User Manual
Page 5

3
Data Out port figure
Package Contents
One Power over Ethernet Injector
Power Cord
User Manual
The Power over Ethernet Injector Power Cord User Guide
Figure 1-1. Package Contents
Compare the contents of your Power over Ethernet Injector package with
the standard checklist above. IF any item is missing or damaged, please
contact your local dealer for service.
Installation
To install the Power over Ethernet Injector, please follow the steps below.
1. Use one end of the RJ-45 cable, which another end is connected to
Data in port on the Power over Ethernet Injector, to connect with the
Switch/HUB.
2. Connect the RJ-45 cable between the Data out port of the Power over
Ethernet Injector and the PoE Splitter, PD (Such as Router, Access
Point
…etc.) or PoE Hub.
3. Plug in the power cord of the Power over Ethernet Injector to the wall
power plug.
4. Before starting, make sure all connections are correct.
The Power over Ethernet Injector connects to the Splitter, POE
Hub or PD via Data Out port.