Microsens MS400080H - Manual (Page 10)

7. Cable Connection Parameter
1000Base-SX/LX network only support full-duplex mode. The Switch-
based Media Converter breaks up TP and Fiber segments’ collision
domain to extend the cabling distance.
• TP Cable Limitations: Cat. 5 and up to 100m
• Converter Fiber Cable Limitations:
Mode
Multi-Mode Fiber
62.5/125μm
Multi-Mode Fiber
50/125μm
Bandwidth
MHz-Km
Distance
Bandwidth
MHz-Km
Distance
1000SX (SC/LC)
850nm
160 220m 400 500m
200 275m 500 550m
1000LX (SC/LC)
1310nm/
1550nm
Single-Mode Fiber 9/125μm
Single-Mode transceiver 1310nm: 10Km
Single-Mode transceiver 1550nm: 30/50Km
Single Fiber Model TX, RX Wavelength
1310nm Single-Mode 10Km
∗ 20Km models are option
TX (Transmit) 1310nm
RX (Receive) 1550nm
1550nm Single-Mode 10Km
∗ 20Km models are option
TX (Transmit) 1550nm
RX (Receive) 1310nm
Note:
The 1310nm and 1550nm models must be installed in pairs, i.e.,
install 1310nm model at one end and 1550nm model at the other one.
8. PoE PSE TP-Fiber Technical Specifications
• Standards : IEEE802.3u 10/100Base-TX, 100Base-FX
IEEE802.3z/ab 1000Base-T
IEEE802.3af Power over Ethernet
• UTP Cable
: Cat. 5 cable and up to100m
• Fiber Cable
: 50/125, 62.5/125 or 100/140
µ
m multi-mode
8.3/125, 8.7/125, 9/125 or 10/125
µ
m single-mode
• PSE Power Feeding Supports :
Alternative A via TP pinout 1, 2, 3, 6
Alternative B via TP pinout 4, 5, 7, 8
• LED Indicators :
POWER, PoE, TP LNK/ACT, SPD, FX LNK/ACT, 4W,7W,15.4W
• Data Transfer Rate :