Microsens Fast Ethernet 2 Port Multifunction Bridge - Manual (Page 2)

Multifunctional Bridge 10/100Base-TX/100Base-FX Page 2/8
MICROSENS GmbH & Co. KG - Kueferstr. 16 - D-59067 Hamm / Germany - Tel. +49 (0)2381/9452-0 - Fax -100 - www.microsens.com
Technical Specifications
Type 2 Port Fast Ethernet Bridge For the coupling of Ethernet and
Fast Ethernet segments for the installation in the
MICROSENS modular chassis
Fiber type Multimode 50 or 62,5/125µm
optional single mode 9/125µm duplex
Opt. output power -19 dBm (1300 nm Multimode min.)
-15 dBm (1300 nm single mode min., 15 km version)
-5 dBm (1300 nm single mode min., 40 km version)
-5 dBm (1550 nm single mode min., 80 km version)
0 dBm (1550 nm single mode min., 125 km version)
Opt. sensitivity -31 dBm (1300 nm Multimode)
-31 dBm (1300 nm single mode, 15 km version)
-34 dBm (1300 nm single mode, 40 km version)
-34 dBm (1550 nm single mode, 80 km version)
-37 dBm (1550 nm single mode, 125 km version)
Max. distance Full duplex: 2 km (Multimode),
15..125 km (Single mode),
Half duplex: 412 m
Cable type Shielded Twisted Pair cable, 100 Ohm, Category 5
Data rate 10 or 100 Mbit/s
Max. distance 100 m
Configuration 10/100Base-TX: Autonegotiation, Auto Crossing
100Base-FX:
manual per DIP-switch
LED displays PWR ready for operation
TX1 first Twisted Pair-connection
FX1 first fiber connection
TX2 second Twisted Pair-connection
FX2 second fiber connection
Power supply 12 V DC / max. 500 mA via backplane
Operating- /Stor.temp. 0°C to 55°C / -20°C to 80°C
Rel. humidity 5% to 80% non condensing
Dimensions 3 HE x 6 TE (128 x 31 mm)
Management Status monitoring and configuration via SNMP/web based
management with management module MS416020
Configuration Hardware level per DIP-switch (DIP-switch 13: off)
per Management (DIP-switch 13: on)