Metz MECABLITZ 50 AF-1 digital Pentax - Manual (Page 95)

95
ķ
Setting procedure
• repeatedly press the„Mode“ ባ button
until„P HSS“ flashes in the display.
The setting takes effect immediately.
After about 5 seconds the display stops
flashing and the setting is saved automa-
tically. „P
HSS“ is shown in the
display.
High-speed synchronisation can be deleted by repeatedly pressing the „Mode“
button until the „HSS“ symbol disappears.
Second curtain synchronisation (REAR) is automatically deactivated when
the flash unit is set to high-speed synchronisation FP or HSS! ☞
TTL
TTL
7.4 Spot-beam mode „Sb“
In the spot beam mode, the AF measuring beam can be used to focus on a
subject at low ambient light level without firing a flash when the shot is taken.
There is no flash-ready indicator in spot beam mode and no exposure control
indicator in the camera viewfinder. The camera is not set to its sync speed and
behaves as though there were no flash unit connected.
Spot beam mode is only activated when the flash unit is switched on and
is flash-ready (check the flash-ready indicator on the flash unit!).
When the camera shutter is released, no flash is fired. Please read the notes on
the AF measuring beam in chapter 12.
Setting procedure
• repeatedly press the„Mode“
ባ button
until„Sb“ flashes in the display.
The setting takes effect immediately.
After about 5 seconds the display stops flashing and
the setting is saved automatically. „Sb“ is shown in
the display.
☞
8,1 m Auto Zoom 35 mm
TTL P TTL P
HSS
☛
HSS
Sb Zoom 35 mm
Sb
☛
709 47 0191.A3 50AF-1 Pen. 17.12.2010 13:22 Uhr Seite 95