Metz MECABLITZ 58 AF-1 digital Pentax - Manual (Page 114)

114
ķ
19.2 Activating the remote flash mode as Controller
• Press the "SEL" button repeatedly until "Select" appears on the display.
• Use the UP
̆ and DOWN ̄ buttons to select "Remote" from the menu. The
selected menu option is indicated by a dark bar.
• Press the "Set" button to confirm the selection of "Remote".
• Use the UP
̆ and DOWN ̄ buttons to select "Remote Master/Control". The
setting is effective immediately.
• Press "Return" repeatedly to return the display to normal. If the "Return"
button is not pressed, the display will switch back to normal automatically
after approximately 5 seconds.
• Press the "Para" button repeatedly until the "Mode" button is also displayed.
• Press the "Mode" button repeated until "Control" appears on display.
Setting the parameters
• Press the "Para" button repeatedly until the desired parameter appears on the
display. Here it is possible to make settings for...
- Channel: Remote channel; channels 1 to 4 are possible
- and MZoom: Reflector position; 24mm (18mm with wide angle attachment)
up to 105mm are possible.
• Use the (+) and (-) buttons to make the desired settings.
• Store the setting with the "Return"
button. If the "Return" button is not
pressed, the settings will be saved automatically after approximately 5
seconds.
19.3 Activating the remote flash mode as Slave
• Press the "SEL" button repeatedly until "Select" appears on the display.
• Use the UP
̆ and DOWN ̄ buttons to select "Remote" from the menu. The
selected menu option is indicated by a dark bar.
• Press the "Set" button to confirm the selection of "Remote".
• Use the UP
̆ and DOWN ̄ buttons to select "Remote Slave". The setting is
effective immediately.
• Press "Return" repeatedly to return the display to normal. If the "Return"
button is not pressed, the display will switch back to normal automatically
after approximately 5 seconds.
The Slave flash unit must be set to the same remote channel as the Master
or Controller flash unit. The Slave flash mode (P-TTL remote) cannot be set
manually on the Slave flash unit, because the Master and Controller flash
units are controlled automatically!
• Store the setting with the "Return" button. If the "Return" button is not
pressed, the settings will be saved automatically after approximately 5
seconds.
Setting the parameters
• Press the "Para" button repeatedly until the desired parameter appears on the
display. Here it is possible to make settings for...
- EV: Flash exposure correction; -3 EV to +3 EV in increments of one third are
possible
- Channel: Remote channel; channels 1 to 4 are possible
- and MZoom: Reflector position; 24mm (18mm with wide angle attachment)
up to 105mm are possible.
• Use the (+) and (-) buttons to make the desired settings.
• Store the setting with the "Return"
button. If the "Return" button is not
pressed, the settings will be saved automatically after approximately 5
seconds.
☞