Metz MECABLITZ 54 AF-1 Minolta - Manual (Page 60)

60
ķ
If a picture is shot before flash readiness is signalled in the camera’s view-
finder, then the flash unit will not be triggered so that the exposure may be
incorrect if the camera has changed over to flash sync speed in the meantime
(see 5.2).
5.2 Automatic flash sync speed control
Depending upon the camera model and camera mode, the shutter speed is
changed to flash sync speed when flash readiness is reached (see camera’s
operating instructions).
Shutter speeds faster than the camera sync speed cannot be adjusted or they
are automatically changed to the camera’s sync speed.
Various cameras have a sync speed range, e.g. 1/30th sec. to 1/125th
sec. (see the camera’s operating instructions). The actual sync speed set
by the camera depends upon the camera mode, the ambient light and
the focal length of the lens used.
Shutter speeds slower than the flash sync speed can be set, depending upon
the given camera model and the selected flash synchronisation (see also
4.6.2 and 4.6.3).
There is no automatic flash sync speed control with the digital cameras
Dimage 5, 7 and 7i. These cameras permit flash shots to be taken at all shut-
ter speeds. Shutter speeds faster than 1/125 sec. should not be used for
shooting situations where full light output of the flash unit is required.
☞
5.3 Displays in the camera’s viewfinder or LCD monitor
5.3.1 Dynax / Maxxum
Symbols in viewfinder: Meaning:
Flash readiness indication:
Flash symbol lights constantly or flashes slowly: The flash unit is
ready for firing.
A flash is fired when the camera’s shutter release is pressed.
Correct exposure confirmation:
Symbol flashes rapidly after shooting:
The picture was correctly exposed.
Symbol flashes:
The existing shooting situation requires the use of flash.
The symbols indicated in your camera’s viewfinder may deviate from
those given in the above table, since some symbols are only possible
on specific cameras. For more details regarding viewfinder informa-
tion please refer to the operating instructions of your camera.
5.3.2 Dimage 5, 7, 7i
The below symbols are only displayed in the camera’s LCD monitor when the
shutter release is lightly touched for activation of the camera’s metering
system. They are not displayed in playback mode (e.g. right after picture
shooting).
Please also refer to the hints given in the operating instructions of your
camera.
(white) The flash unit is switched on and ready for firing.
(red)
The flash unit is switched on but not yet ready for firing.
(blue) The shot was correctly exposed. This symbol may only briefly be
indicated after shooting.
☞
54 AF-1 M 03.08.2004 10:53 Uhr Seite 60