Denon AVR-3808CI User Manual
Page 5
Page 5 of 6
Questions or problems, please call Denon USA Customer Support @ 800-497-8921
9. Total update time is approximately 35 to 50 minutes depending on the DPMS server and the Internet
environment of the unit’s location. Progress Indications from the front panel display are as follows:
STEP
FL DISPLAY INDICATION
1
Please Wait…
2
Main Firm **min.
Updating **%
3
Sub Firm **min.
Updating **%
4
SFPGA Firm **min.
Updating **%
5
VFPGA Firm **min.
Updating **%
6
VPLD Firm **min.
Updating **%
7
DSP1 Firm **min.
Updating **%
8
DSP2 Firm **min.
Updating **%
9
Sflash Firm **min.
Updating
10
Ether BL **min.
Updating
11
Ether WP **min.
Updating ***
12
Ether IM **min.
Updating ***
13
Firm Update
Updating Complete
10. Master Power ‘Off’ then ‘On’ of the AVR. Resume normal operation, unless Firmware Update #1 was done
at the same time, then the unit has been reset back to Factory Default and must be re-setup fully.
To verify completed firmware (#1+#2, or just #2) updating by the unit, check the firmware versions shown below. To
check the firmware version numbers, do the following:
4. Turn Master Power ‘Off’
5. While holding down the ‘Status’ and ‘Return’ buttons on the front panel, press Master Power ‘On’.
6. Release the ‘Status’ and ‘Return’ buttons. With each press of the ‘Status’ button, the following names and
version numbers are indicated on the front panel display of the receiver.
NAME
VERSION
1
Main
01.57
2
Sub
00.38
3
DSP1
36.49
4
DSP2
39.41
5
FPGA (Audio)
00.50
6
PLD (Video)
-
7
GUI Config
A070629B
8
GUI Serial
P0007621
D37750008