Meinberg PZF510 - Manual (Page 11)

11
DIST.o.T
The distance to the transmitter is entered in this menu for compensating the propagati-
on delay of the received pseudo-random code. This setting should be done as exact as
possible because the absolute precision of the time frame is influenced by this value.
After pressing the 'Set'-button a four digit kilometer-value is displayed. By pressing
the 'Set'-key again, the first position is selected (flashing digit). To choose a different
digit, the 'Menu'-key has to be pressed, to increment the current digit the 'Set'-button
must be used. If the value is entered, it will be stored by pressing the 'Menu'-key until
the display returns to the setup submenu. The km-value is stored in the internal
EEPROM of the board.
SYNTH.
The output frequency of the internal synthesizer is selected in this menu. This can be
done in the range of 1/3Hz to 9.999MHz.
After setting the frequency (the buttons are used the same way as for setting the km-
value) it will be stored in the battery-backed RAM of the PZF510. This value is
available directly after a reset therefore.
SYNTH M.
This menu configueres at which time after power-up the frequency generation of the
synthesizer starts. The following settings are possible:
allways
Frequency-generation immediately after reset.
aft. SYN
The clock has to synchronize first before the frequency-generation starts. Frequencies
less than 10kHz are phase locked to the precise pulse per second at once.
TIME REF
The selection of timezone MEZ/MESZ or UTC can be done in this menu.
PAR.COM0
Framing and baud rate of the serial channel COM0 are set in this submenu. The
following parameters are possible:
Baud rate: 600, 1200, 2400, 4800, 9600 Baud
Framing:
7O2, 7N2, 7E1, 7E2, 8N1, 8N2, 8E1