Dodge 2009 Dodge Ram Pickup 2500 User Manual
Page 30
The two trip odometers show individual trip mileage. To
switch from odometer to trip odometers, press and
release the Trip Odometer button.
To reset a trip odometer, display the desired trip odom-
eter to be reset then push and hold the button (approxi-
mately two seconds) until the display resets.
Vehicle Warning Messages
When the appropriate conditions exist, messages such as
“door” (indicates that a door(s) may be ajar), “gASCAP”
(which indicates that your gas cap is possibly loose or
damaged), and “noFUSE” (indicates that the IOD fuse is
removed from the Integrated Power Module), will dis-
play in the odometer.
NOTE:
There is also an engine hour function. This
indicates the total number of hours the engine has been
running. To display the engine hours perform the follow-
ing: Place the ignition in RUN, but do not start the
engine. With the odometer value displayed, hold the trip
button down for a period of six seconds. The odometer
will change to trip value first, then it will display the
engine hour value. The engine hours will be displayed
for a period of 30 seconds until the ignition is turned off
or the engine is started.
DPF Full
The messages “dPF” and “FULL” will alternately display
in the odometer when Diesel Particulate Filter (DPF)
service is required. Refer to “Overhead Console with
Electronic Vehicle Information Center (EVIC)” in Sec-
tion 3 for more information.
16. Front Fog Light Indicator Light — If Equipped
This indicator will illuminate when the front fog
lights are on.
28
UNDERSTANDING YOUR INSTRUMENT PANEL