MEGA Corp. MMP4-5 - Manual (Page 5)

MMP4-5
13 Feb 2012
SECTION 1
Definitions and Abbreviations
1-2
SAFETY MESSAGES
There are several specific safety messages on
this machine. The exact location of the hazards
and description of the hazards are reviewed in
this section. All personnel working on or
operating the machine must become familiarized
with all the safety messages.
Make sure that all of the safety messages are
legible. Clean the safety messages or replace the
safety messages in you cannot read the words.
Replace the illustrations if the illustrations are
not legible. When you clean the safety
messages, use a cloth, water and soap. Do not
use solvent, gasoline or other harsh chemicals to
clean the safety messages. Solvents, gasoline or
harsh chemicals could loosen the adhesive that
secures the safety messages. Loose adhesive
will allow the safety messages to detach.
Replace any safety message that is damaged or
missing. If a safety message is attached to a part
that is replaced, install a new safety message on
the replacement part.
Toxic Gas Hazard (1)
This safety label is located on the side of the tank
and at all water fill entrances.
Cutting or welding operation on the inside of
the tank can cause the accumulation of toxic
gases. Read and understand instructions and
warnings in the Maintenance Manual.
Failure to provide proper ventilation or
breathing apparatus while conducting these
operations may result in serious injury or
death.
Do Not Operate (2)
This safety label is located on the outside of the
front and rear control boxes. (If equipped)
Do not open this control box unless you read
and understand the instructions and warnings
in the Operator and Maintenance Manual.
Failure to follow instructions or heed the
warnings could result in serious injury or
death.