MEGA Corp. MPT - Manual (Page 22)

6-1
MPT12 Manual
26 Mar 2014
SECTION 6
Scheduled Maintenance Inspections
Contents
DESCRIPTION
This section establishes scheduled maintenance inspections of the MPT at the designated frequencies.
Performing these inspections will identify potential system discrepancies and allow preventative maintenance
to be performed before a component or system is rendered totally inoperative.
**NOTE: The recommended oil change intervals are based upon operating conditions, speeds, and loads.
Limited service applications may allow the recommended interval to be increased. Sever service applications
may require the recommended interval to be reduced. For more information, contact Mega Product Support at
U.S. Toll Free 1-800-345-8889 or Direct 1-505-345-2661 or visit our website at www.megacorpinc.com for more
contact information.
FREQUENCY
AXLE AND BRAKE SYSTEM 1000 MILES 30,000 MILES 100,000 MILES EVERY 6 MONTHS ANNUALLY
Check oil level. Change oil if the oil level is less than 0.25”.
Additionally, change the oil and grease the bearings
whenever the wheel end is disturbed during wheel or hub
removal or if the oil is contaminated.
X
(Heavy‐Duty Service) If the MPT accumulates over 60,000
miles a year, change the oil and grease the bearings every
30,000 miles.
X
(Heavy‐Duty Service) If the MPT accumulates less than
60,000 miles a year, change the oil and grease the
bearings every six months.
X
(Standard‐Duty Service) If the MPT accumulates over
100,000 miles a year, change the oil and grease the
bearings every 100,000 miles.
X
(Standard‐Duty Service) If the MPT accumulates less than
100,000 miles a year, change the oil and grease the
bearings once a year.
X
Check brake pods for security, damage, and leaks X
FREQUENCY
STEP
MPT STRUCTURE
150 HRS
(WEEKLY)
250 HRS
(BI‐WEEKLY)
500 HRS
(MONTHLY)
1,000 HRS
(QUARTERLY)
5,000 HRS
(ANNUALLY)
1
Check filler port trash screen for debris and
inspect assembly for security and damage. Repair
or replace trash screen as required.
X
2
Visually inspection tank exterior for damage and
evidence of leaks. Repair as required
X
3
Check all lights for proper operation. Replace
lights as required.
X
4
Check all interior tank structure for leaks, cracks
and condition of epoxy coating (if equipped).
Repair structure and coatings as required.
X
Description .........................................................................6-1
Axle and Brake System ...................................................6-1 MPT Structure ...................................................................6-1
Control System .................................................................6-2