MBM Corporation TRIUMPH 5551-06 EP (99 STEP MODULE) - Manual (Page 18)

- 18 -
123456789012345678
123456789012345678
123456789012345678
123456789012345678901
123456789012345678901
123456789012345678901
EBA 551-06 • EBA 551-06 LT
Start machine
• Main switch
F
to position "
I", Pull out blade
locking key H .
• Press S button Q backgauge I moves to
the rear and searches for the reference
position, wait until a measurement is shown
in the display
D
(57 cm or 22,44 inches).
Warning!
Before storing or cutting a measurement
please check if the correct measurement
scale (cm or inch) is stored (LED lights). For
information on how to store see picture below
left.
Cutting to specified dimensions
• Enter dimension on the numerical key pad
S LED "
S" Z lights.
(If a wrong dimension is entered this can be
corrected by pressing the
s button).
• Press S button dimension is
approached, LED "
S" disappears.
With the false clamp measurements
between 6 cm and 8 cm can only be
approached with the hand-wheel
G
. See
page 14.
• Insert paper and move by means of the
stacking angle to the backgauge
I
and side
lay on the left
J
.
• Release the cut.
Cut according to markings
• Adjust the backgauge with the hand-wheel
or crank handle G to the back.
• Insert paper and move by means of the
stacking angle b to the backgauge
I
and
side lay on the left J .
• Turn the hand-wheel G to the right until the
marking on the paper to be cut is below the
cutting line indicator.
• The further the hand-wheel
G
is turned to
the right, the quicker the backgauge moves.
If the hand-wheel is turned to the left the
backgauge will return quicker.
• Release the cut.
GB • Bedienung
• Operation •