MBM Corporation 46 Installation - Manual (Page 4)

Page 4 (13) Art. nr 45961 Sep 2000
T09120
3. Choose “CHECK MOTORS” and press the “OK”
button.
S E L F D I A G N O S I S
C H E C K M O T O R S
C H E C K S E N S O R S
V O L T M E T E R
A C T I V E S T O P P O S .
M 1 R E S E R V E D
M 2 E N V . F L A P O P .
M 3 E N V . P O S I T I O N
M 4 E N V . O P N E R
M 5 P A P E R T R A N S P .
S P E E D = 2 . 0 0 M / S
S P E E D = 2 . 0 0 M / S
6. Press the wrench button if the motor does not run at
the specified speed. The Model 45 will automatically
adjust the speed. Press the stop button to store
value.
4. Select motor and press the “OK” button
5. Run the motor by pressing the directional arrow
button.
Motor Normal reading Description
M3 SPEED=2,00 M/S ENV. POSITION
M5 SPEED=2,80 M/S PAPER TRANSP
M8 SPEED=2,90 M/S ENV. SEALING
Enter the service mode by:
1. Pressing and holding the rightmost button pressed on
the control panel.
2. Switching on the power.
1
2
CALIBRATING MOTORS
After upgrading the software motors 3, 5 and 8 needs to be calibrated. Motors should allways
be allowed to cool off (if used) before calibration.
7. After calibration, press the ”ESC” button one time