Caution, 2) if paper scrap remains on the machine, Power it off. otherwise, injury could occur – MBM Corporation AEROCUT G2 User Manual

Page 43

４２

(2) If Paper scrap remains on the machine

① When the paper jams near the stacker panel or when maintenance work is done, the

stacker panel can be opened.

② Shift the right and left lock levers of the stacker panel to the inner side, and pull the upper

part by hand to open.

③ Pick up paper scraps with

Tweezers and take them away.

④ With the stacker panel opened, the machine cannot be operated, resulting in Cover open

error.

⑤ To reposition the stacker panel, just close it.

⑥ If the paper scrap remains in cutter cover.

If Paper scrap remains under the Cutter cover of the machine, turn off the machine and take

off thumb screw to remove the anti-static brush setting plate. After removing plate there will

be a space. Push the paper t scrap down with Waste ejector, which comes with machine.

Caution

Power it off. Otherwise,
Injury could occur.

Cutter cover

Anti-static Brush Setting Plate

Waste ejector

Thumb screw

Stacker panel

Lock lever