MBM Corporation HIGH CAPACITY STACKER - Manual (Page 5)

1. Precautions before installation and use
1.1 Place for installation
Avoid installing the machine in the following places for the sake of safety and to prevent mechanical
problems.
[Precautions for installation]
・Locations with extremely high or low temperatures. Room temperature should be between 5 and 35
degrees centigrade.
・Locations with the potential for producing electrical leaks, for example, owing to splashing water.
・Near hear sources
・Places exposed to wind
・Narrow spots with poor ventilation, or dark places
1.2 Installation
Caution
Install the machine on a stable and level place. Otherwise, it may cause mechanical troubles.
Avoid installing the machine in humid and/or dusty places. It may cause fire or an electrical shock.
Set the collator on the collator table at a position about 55 mm from
its left edge (as viewed from the operator’s side).
Caution!
・The position of the collator’s rubber legs will be deviated from
the round slot for setting the rubber legs on the machine table.
・In case two connected collators are used, place UC-1100L (Left
tower) in the position shown on the drawing on the right and
place UC-1100 (Right tower) in the normal position (round
dent on the cover panel of the collator table).
1.3 Confirmation of contents and attachments
After unpacking the collator, check the attachments. Should any part be missing, contact your dealer
immediately.
(1) Machine body (2) Paper butt unit (3) Dolly (4) Forceful ejector (5) Right guide for straight stacking
- 4 -