MBM Corporation Paper Drill 200 single spindle User Manual
Page 13
13
TROUBLE SHOOTING GUIDE
PROBLEM:
Drill bit not concentric.
CAUSE
Foreign material in chuck or on drill-plug.
CORRECTION:
Inspect and clean.
CAUSE:
Drill bit bent.
CORRECTION:
Replace.
CAUSE:
Drill bit not inserted and/ or in chuck properly. Reinsert drill bit
CORRECTIONS:
Correctly.
CAUSE:
Chuck not tight to spindle.
CORRECTION:
Tighten set screw.
PROBLEM:
Drill bit not drilling.
CAUSE:
Drill bit plugged.
CORRECTION:
Remove and clear chips. Check for other foreign matter.
CAUSE:
Drill bit dull.
CORRECTION:
Sharpen. (Follow factory cutting angle.)
NOTE:
In extreme conditions, drill chuck and/or chip chute may be plugged. Remove
drill, loosen chip chute, pull down, and clean. See Operation Manual.
PROBLEM:
Traverse table drags or skips during operation.
CAUSE:
Roller bearings dry or damaged.
CORRECTION:
Remove table, lubricate.
CAUSE:
Table guides out of adjustment.
CORRECTION:
Adjust.
CAUSE:
Table damaged.
CORRECTION:
Check table for damage. Repair or replace.
NOTE:
In order to maintain a smooth table operation, DO NOT sit on, lean on, or
force table out of alignment.