Important safety instructions, Grounding instructions, Save these instructions – Maytag MMV4205BAS User Manual
Page 3
3
WARNING
To avoid risk of electrical shock or death, this oven must
be grounded and plug must not be altered.
GROUNDING
INSTRUCTIONS
Oven MUST be grounded. Grounding
reduces risk of electric shock by
providing an escape wire for the
electric current if an electrical short
occurs. This oven is equipped with a
cord having a grounding wire with a grounding plug. The
plug must be plugged into an outlet that is properly installed
and grounded. See Installation Instructions.
Consult a qualified electrician or servicer if grounding
instructions are not completely understood, or if doubt
exists as to whether the oven is properly grounded.
Do not use an extension cord. If the product power cord
is too short, have a qualified electrician install a three-slot
receptacle. This oven should be plugged into a separate
60 hertz circuit with the electrical rating as shown in
specifications table. When the oven is on a circuit with other
equipment, an increase in cooking times may be required
and fuses can be blown.
Microwave operates on standard household current, 110-
120V.
FEDERAL
COMMUNICATIONS
COMMISSION
RADIO FREQUENCY
INTERFERENCE
STATEMENT (U.S.A.
ONLY)
This equipment generates and uses ISM frequency energy
and if not installed and used properly, that is in strict
accordance with the manufacturer's instructions, may
cause interference to radio and television reception. It has
been type tested and found to comply with limits for ISM
Equipment pursuant to part 18 of FCC Rules, which are
designed to provide reasonable protection against such
interference in a residential installation.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following:
• Reorient the receiving antenna of the radio or television.
• Relocate the microwave oven with respect to the receiver.
• Move the microwave oven away from the receiver.
• Plug the microwave oven into a different outlet so that the
microwave oven and the receiver are on different branch
circuits.
The manufacturer is not responsible for any radio or
television interference caused by
unauthorized
modification to this microwave oven. It is the responsibility
of the user to correct such interference.
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
MMV4205BA_03143Z.indb 3
2008-01-03 ソタネト 3:33:21