beautypg.com

Operating fireplace – Desa (V)VC36NE Series User Manual

Page 28

background image

www.desatech.com

116235-01G

28

6. Wait five (5) minutes to clear out any gas.

Then smell for gas, including near the floor.

If you smell gas, STOP! Follow “B” in the

safety information in cloumn 1. If you don't

smell gas, go to the next step.

7. Turn the equipment shutoff valve counter-

clockwise

to the ON position. Do not

force.

8. Close lower louver panel.

9. Turn on all electric power to the appliance.

10. Turn the wall switch to the ON position.

11. Visually locate the pilot. The ignitor should

begin to spark and the main burner should

ignite once flame appears at pilot.

• If lighting the appliance for the first time

each season, it may take several attempts

before the supply gas can reach the pilot

and main burners.

• If the appliance will not stay lit after several

attempts, follow the instructions under To

Turn Off Gas To Appliance and call your

service technician or gas supplier.

TO TURN OFF GAS

TO AppLIANCE

1. Turn off the wall switch.

2. Turn off all electric power to the appliance

if service is to be performed.

3. Open lower louver panel.

4. Remove front hearth brick and control

access panel.

5. Turn equipment shutoff valve clockwise

to OFF. Do not force.

6. Close lower louver panel.

OPERATING FIREPLACE

FOR YOUR SAFETY

READ BEFORE LIGHTING

WARNING: If you do not fol-

low these instructions exactly,

a fire or explosion may result

causing property damage, per-

sonal injury or loss of life.

A. This appliance has a pilot which must be

lighted by hand. When lighting the pilot,

follow these instructions exactly.

B. BEFORE LIGHTING smell all around the

appliance area for gas. Be sure to smell next

to the floor because some gas is heavier than

air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

• Do not try to light any appliance.

• Do not touch any electric switch; do not

use any phone in your building.

• Immediately call your gas supplier

from a neighbor's phone. Follow the gas

supplier's instructions.

C. Do not use this appliance if any part has

been under water. Immediately call a

qualified service technician to inspect the

appliance and to replace any part of the

control system and any gas control which

has been under water.

LIGHTING

INSTRUCTIONS

NOTICE: During initial operation

of new heater, burning logs will

give off a paper-burning smell.

Orange flame will also be pres-

ent. Open damper or window to

vent smell. This will only last a

few hours.

1. STOP! Read the safety information

above.

2. Turn off all electric power to the fireplace.

3. Turn wall switch to the OFF position.

4. Open lower louver panel.

5. Turn equipment shutoff valve clockwise

to the OFF position (see Figure 42).

Do not force.

Figure 42 - Turning Equipment Shutoff

Valve to the OFF Position

Equipment
Shutoff Valve

Pilot Adjustment Screw

Sensing
Rod

Pilot
Burner

Ignitor

Figure 43 - Pilot