Mathey Dearman 8SA Saddle Machine - Manual (Page 5)

5
Figure 1: Spacer Configuration for 40”, 42” & 48” pipe
Table 1 – Spacer Bolt Part Identification
4.0 Installation of Saddle Machine on Pipe
4.1 Place the Saddle Machine squarely on the pipe, as close as possible to the cut line. All 4 spacer bolts
should contact the pipe.
4.2 Place the hook of the Boomer (Figure 2 item 1) into the Boomer Eye (Figure 5 Item 9) located on the
Saddle (Figure 5 Item 1).
4.3 Place the Spring Snap (Figure 2 Item 4) into the Boomer Eye (Figure 5 Item 9) on the other side of the
Saddle (Figure 5 Item 1).
4.4 In order to get a stable installation of the 8SA Saddle Machine, the Spring Snap (Figure 2 Item 4) of
the Boomer Assembly (Figure 2) must be adjusted on the Chain (Figure 2 item 3) so that the spring
(Figure 2 Item 2) is stretched approximately 1/2" -3/4” (12 - 19mm) when the Boomer is closed.
4.5 When the Chain is properly adjusted, close the Boomer (Figure 2 item 1).
ITEM # PART DESCRIPTION Length PART # QUANTITY REQ.
1 Spacer Bolt for 40”/ 1016mm pipe 1/4"/ 6.4mm 03-0110-004 4
2 Spacer Bolt for 42”/ 1067mm pipe 3-1/4”/ 83mm 03-0110-008 4
3 Spacer Bolt for 48”/ 1219mm Pipe 4-1/4”/ 108mm 03-0110-009 4
4 Hex Nut, 1/2 - 13 1H-12C0-000 4
5 Spacer Bolt Kit (includes all of the above) 03-08SA-KIT 1
Caution:
Improper tensioning of the boomer assembly or failure to latch the boomer
assembly may result in injury.