Denon AVR-1508 - Manual (Page 24)

Get
ting Star
ted
Connections
Pla
ybac
k
Remot
e Contr
ol
Multi-Zone
Inf
or
mation
Tr
oubleshooting
ENGLISH
Set
up
k ~ A5 Distance
Set distance from listening position to speakers.
Before making the settings, measure the distance from the
listening position to the different speakers.
[Display]
1 . S p 2 . I n 3 . O p
Q
S p e a k e r S e t u p
Q
8 F L 1 2 f t
Q
1 5 S W 1 2 f t
Distance measurement
Select the speaker you want to set, then set the distance.
Set the value closest to the measured distance.
[Variable range]
0ft ~ 60ft
: Settable in units of 1 foot.
NOTE
Set the distance between the listening position and the various
speakers to no more than 20 ft.
A6 Crossover Frequency
Select crossover frequency from which subwoofer handles low
range signal.
[Display]
1 . S p 2 . I n 3 . O p
Q
S p e a k e r S e t u p
Q
1 6 C r . O v e r 8 0 H z
[Selectable items]
40Hz 60Hz 80Hz 90Hz 100Hz 110Hz 120Hz 150Hz
200Hz 250Hz
:
Only the portion of the bass sound of the various speakers output
from the subwoofer that has a frequency below the frequency set
here is output.
Set this according to the low frequency reproduction capabilities of the
speakers you are using.
• The “Crossover Frequency” can be set when there are speakers that
have been set to “Small” at “System Setup” – “Speaker Setup” or
when “Subwoofer” is set to “Yes” (vpage 20).
• For speakers set to “Small”, sound below the crossover frequency
is cut from the sound output. The cut bass sound is output from the
subwoofer or front speakers.
• Always set the crossover frequency to “80Hz”. When using small
speakers, however, we recommend setting the crossover frequency
to a higher frequency.
A7 Test Tone
Adjust channel levels to obtain equal volume from all speakers.
[Display]
1 . S p 2 . I n 3 . O p
Q
S p e a k e r S e t u p
Q
1 7 T . T o n e Y e s <
Q
T . T o n e A u t o >
Q
T e s t T o n e O n
Q
A u t o - F L
Test Tone
Select test tone playback method.
[Selectable items]
Auto
: Automatically switch speaker from which test tone is
output.
Manual
: Manually switch speaker from which test tone is output.
Test Tone Start
Press the o button to select “Yes”, then press the o p button to select
“Auto” or “Manual”.
Then press the i button. Out put the test tone.
Auto : Press the o p button to adjust the volume.
Manual : Press the u i button to select the speaker, then press the
o p button to adjust the volume.
When the adjustments are completed, press the ENTER button to
finish the test tone.
[Variable range] –12dB ~ 0dB ~ +12dB
Operations ( v page 19)