D-Link DI-714 - Manual (Page 13)

13
Front Panel
The front panel provides LED lights to indicate the status of the unit.
Refer to the following table for the meaning of each LED feature.
Power
Power status of the DI-714. A steady LED indicates that
the power is “on.” No LED light indicates lack of power.
Status Router status indicator. When the router starts up, the Status
LED will briefly blink. If the unit is defective, then the
indicator will be constantly “on.”
Broadband Wide Area Network status. When connected to the
Cable/DSL modem, the LED indicator light is “on.”
Dial-Up Indicates Dial-Up modem status. When modem connection
is established then the LED indicator light is “on.”
Wireless Indicates the status of the Wireless Access Point (AP.) When
the Wireless AP is ready, the LED indicator is “on.”
Local
Ethernet
1 2 3 4
(Link/Act) Indicates link and activity of each Local Ethernet port.
When a device (computer, hub or switch) is connected to
one of the Ethernet ports, the LED indicator is “on.” During
data transfer, the LED indicator light is “blinking.”
Rear Panel
The rear panel features the Local Ethernet ports, Broadband port, Dial-up
Modem port and Factory Reset button. Refer to the following table for the
meaning of each feature.
POWER
5V / DC
Used to connect to the power outlet. Only use the power
adapter provided with the DI-714. Use of an
unauthorized power adapter may cause damage to your
device and violate your warranty.
BROADBAND The RJ-45 Ethernet port labeled “Broadband” is used to
connect your DI-714 to your DSL or Cable modem.
DIAL-UP
MODEM Port used to connect an external backup modem.
RESET Resets the configuration to default factory settings.