Marantz MA6100 - Manual (Page 6)

6
ENGLISH
Nq Nq Nq Nq Nq POWER switch
Press the button to turn power on (POWER ON mode), and
press it again to turn power off (POWER OFF mode). When it
is required to remote control the power mode of the MA6100,
be sure to leave this switch in the POWER ON mode.
Nw Nw Nw Nw Nw POWER ON indicator
A POWER ON/ STANDBY indicator The indicator glow red
when the unit is in Standby mode and blue when the unit is On.
e e e e e
Audio INPUT jack
Connect the preamplifier output to this jack.
r r r r r
Audio INVERT OUTPUT jack
This jack is for output of signal which was inverted from the
normal input signal.
t t t t t
REMOTE CONT. IN jack
Connect with the remote control output jack of a component
which is compatible with MARANTZ remote control system.
The remote control allows to switch the power of the MA6100
between the “POWER ON” mode and “STANDBY” mode.
y y y y y
REMOTE CONT. OUT jack
Connect with the remote control input jack of a component
which is compatible with MARANTZ remote control system.
u u u u u EXT. CONT IN jack
Not connected when the power is to be controlled from a
MARANTZ remote control unit.
Connect to the video signal output of a video component when
the power is to be controlled based on a video signal.
The external control allows to switch the “POWER ON” and
“STANDBY” modes of the unit according to the “presence”
and “absence” of video signal.
When the video signal becomes absent while the power of the
unit is on, it enters the “STANDBY” mode in about 4 seconds;
the unit enters the “POWER ON” mode again when the video
signal is input again.
As the control data of the EXT. CONT IN jack is also output at
the REMOTE CONT. OUT jack, the MA6100 units connected
after this unit can also be switched between the “POWER ON”
and “STANDBY” modes.
Leave Power switch q in the ON position.
* External control using a signal from 5 to 13 V in place of video
signal is also possible using this jack. However, as this scheme
belongs to the professional use, please consult MARANTZ if
you want to adopt such an external control scheme.
i i i i i SPEAKER SYSTEM terminals
Connect with speakers using speaker cords. Respect the +
and - polarity when connecting speakers.
Use speakers with an impedance of 8 to 16 ohms.
o o o o o
Power cord
Insert the plug at the extremity of the power cord into a 230 V
AC household AC outlet.
To Enjoy sound with a higher quality, it is recommended to
match the power connection polarity with other components.
The white-lined wire of the power cord is the neutral (GND)
wire.