Marantz PM-15S2 - Manual (Page 15)

9
ENGLISH
NAMES AND FUNCTIONS
BASIC CONNECTIONS
BASIC OPERA
TIONS
ADV
ANCED CONNECTIONS
ADV
ANCED OPERA
TIONS
TROUBLESHOOTING
OTHERS
BASIC CONNECTIONS
BASIC CONNECTIONS
STEREO
BI.AMP
R CH L CH
SPEAKER SYSTEMS
IN OUT
F.C.B.S.
SPEAKER IMPEDANCE : 4 - 8 OHMS
Set to “STEREO”
L CH speaker R CH speaker
CONNECTING SPEAKER SYSTEMS
• Be sure to use speakers with the specified impedance as shown on the rear panel of this unit.
Note:
• To prevent damage to circuitry, do not let the bare speaker wires touch each other and do not let them touch any metal part of this
unit.
• Do not touch the speaker terminals when the power is on. It may cause you to receive an electric shocks.
• Do not connect two or more speaker cables to a speaker terminal at the same time. If you do so, this unit may be damaged.
• Be sure to connect the positive and negative cables for the speaker properly. If they are miss-connected, the signal phase will be
reversed and the signal quality will be corrupted.
PM-15S2_UN_01_Eng.indd 9 PM-15S2_UN_01_Eng.indd 9 09.5.18 2:57:00 PM 09.5.18 2:57:00 PM