Marantz PM7005 - Manual (Page 20)

Connecting a playback device
You can connect turntables, tuners, CD players and network audio players to this unit.
This unit is compatible with turntables equipped with a moving magnet (MM) phono cartridge. When you connect to a turntable with a low output moving
coil (MC) cartridge, use a commercially available MC head amp or a step-up transformer.
If you set this unit’s input source to “PHONO” and you accidentally increase the volume without having a turntable connected, you may hear a hum noise
from the speakers.
NOTE
The earth terminal (SIGNAL GND) of this unit is not for safety grounding purposes. If this
terminal is connected when there is a lot of noise, the noise can be reduced. Note that
depending on the turntable, connecting the ground line may have the reverse effect of
increasing noise. In this case, it is not necessary to connect the ground line.
GND AUDIO
OUT
L
R
AUDIO
OUT
L R
AUDIO
OUT
L R
AUDIO
OUT
L R
L
L
R
R
L
L
R
R
L
L
R
R
Network audio
player Tuner
Turntable
CD player
Contents Connections Playback Settings Tips Appendix
20 Front panel Rear panel
Remote control
unit
Index