Marantz SR6006 Getting Started - Manual (Page 7)

4
ENGLISH DEUTSCH FRANÇAIS ITALIANO ESPAÑOL NEDERLANDS SVENSKA
When preparations are complete, start the Setup Wizard.
Use the Setup Wizard to perform connections and settings as shown in the following steps. Perform the operations as described in the
instructions on the screen. You can skip or cancel at each section if necessary.
SETUP WIZARD
This completes the Setup Wizard.
Network Setup NETWORK SETUP
Please connect LAN cable to
ETHERNET port on rear panel
of receiver, and other side of
cable to network router.
When connection is complete,
press “Next” to continue.
Next
RETURN Back to TOP Enter
Configure to playback audio files saved
onto a computer or Internet radio.
These settings can be changed in the following menu even after setting the Setup Wizard
( vm page 112 “Network Setup”).
5
Source Setup SOURCE SETUP
Please select device.
Source BD
Device Blu-ray Disc player
Player
Video
RETURN Back to TOP Enter Select
Set the connecting terminals for each
device to be set, and connect to the
terminals.
These settings can be changed in the following menu even after setting the Setup Wizard
( vm page 93 “Input Assign”).
4
Speaker Calibration SPEAKER CALIBRATION
For preparation, the setup
microphone which included
in the box is required.
Please connect the
microphone connector to the
SETUP MIC jack on front
panel.
RETURN Back to TOP
Configure the settings for your speakers,
and for the optimum surround sound for
your room.
These settings can be changed in the following menu even after setting the Setup Wizard
( vm page 20 “Set up speakers (Audyssey® Auto Setup)”).
3
Speaker Connection
SPEAKER CONNECTION
Please select the speaker
configuration to be used.
7.1ch adds 2 more speakers
to 5.1ch, for enhanced
surround.
7.1ch
Others
5.1ch
RETURN Back to TOP Enter Select
Connect the speakers for surround sound.
NOTE
Connections for speakers other than 7.1 channel or 5.1
channel speakers cannot be set using the Setup Wizard.
Select “Others”, and then select “Skip” in “2. Speaker Connection” to proceed to “3. Speaker
Calibration”. (For details on the setting method, see m page 60 “Speaker installation/connection
(Advanced connection)”.)
2
Language Select
LANGUAGE SELECT
Please select the language for the on screen menu.
Español
English
RETURN Back to TOP Enter Select
Set the language for the instructions on
the television screen.
These settings can be changed in the following menu even after setting the Setup Wizard
( vm page 120 “Language”).
1