Lynx Studio Hilo Version 5 Firmware - Manual (Page 3)

1.2.1 Sync Source
When the LT-USB is NOT connected to the computer,
the Sync Source may be changed to one of the following
four choices:
• Internal: Clock driven by the Hilo’s crystal oscillator
• Word Clock: Clock derived from the WORD
CLOCK input
• Digital: Clock derived from the active digital input
• ADAT In: Clock derived from the ADAT input.
Once an ADAT signal is detected on the Optical
Input, Hilo automatically switches the Optical input
from S/PDIF to ADAT. In this mode, the additional
ADAT inputs will appear as available channels on
the output mix routing page; meter source selection
and the test tone page.
Please note that Word Clock/2 and Word Clock/4 are not
available in version 5 firmware.
1.2.2 Output Mix Routing Page
1.2.2.1 Solo Button
The new Solo button allows any active input channel to
be isolated. This allows very rapid comparison of sources,
A/B switching, and a convenient way for troubleshooting
audio anomalies.
Simply press the Solo button and it will engage and turn
green with the word “Solo” blinking.
In this state, press any input source button and you will
hear that audio exclusively. Pressing any other input
source will instantly switch to the alternate source.
When done, tapping the Solo button returns Hilo to the
previous state, where multiple input sources can stream to
an output simultaneously.