Luminox 1800 Series - Manual (Page 7)

I
30
10 20
12
3
6
9
12
2
4
6
8
10
1 11
3
5 7
9
15
60
30
45
3 1
31
Alarm time Push-button
Note
The alarm cannot be used as long as
the chronograph is in operation.
Setting the alarm time
Activate the setting mode
Press the push-button for at least
2 seconds. As soon as the small minute
hand jumps forward one minute, this
mode is active.
Setting
Short pressing (less than 1 second):
the alarm time is moved forward by the
minute.
Long pressing (longer than 2 seconds):
the alarm time is moved forward until the
push-button is released.
Please note:
If the push-button is not activated for
10 seconds, the setting mode of the alarm
time deactivates itself. At the same time,
two beeps are emitted to indicate that the
alarm is switched on.
I
30
10 20
12
3
6
9
12
2
4
6
8
10
1 11
3
5 7
9
15
60
30
45
3 1
31
Alarm time Push-button
Switching the alarm on / off
The alarm is switched on / off by briefly
pressing the push-button:
2 beeps alarm switched on
1 beep alarm switched off
Please note:
The alarm can be set a maximum of 12 hours
before the desired alarm time.
Once the set alarm time has been reached,
a signal is emitted for 20 seconds.
This signal is repeated after two minutes.
Following brief pressing of the push-button,
the signal is immediately switched off.