I would like to enable or disable the laser mark, I would like to freeze images, I would like to capture images – Lumens Technology CL510 User Manual
Page 18: 6 i would like to enable or disable the laser mark, 7 i would like to freeze images, 8 i would like to capture images
English - 17
2. Press [BRT -] on the Remote Control to dim the display.
6.6 I would like to enable or disable the laser mark
1. Press the [LASER] on the Remote Control to enable/disable the laser
mark.
6.7 I would like to freeze images
1. Press [FREEZE] on the Remote Control to freeze the current image on
the screen.
6.8 I would like to capture images
6.8.1 Capturing and saving images
1. Press [CAPTURE] on the Remote Control to capture and save
images.
You cannot capture images when the capture mode is set to
[Disable]. If it is set to [Continuous], you can capture images
continuously. Press [CAPTURE] to start capturing
continuously, or press [CAPTURE] again to exit.
To change the quality of captured images, please refer to
6.8.2
Setting the quality of captured images
.
To change the settings of captured images, please refer to
6.8.3 Setting continuous capture
.
6.8.2 Setting the quality of captured images
1. Press [MENU] on the Remote Control to enter the setting menu.
2. Press [] or [] to the [Storage] menu.
3. Press [] to find [Image Quality].
4. Press [] or [] to select among [High/Normal/Low].
5. Press [MENU] to exit.
6.8.3 Setting continuous capture
1. Press [MENU] on the Remote Control to enter the setting menu.
2. Press [] or [] to the [Setting] menu.
3. Press [] to find [Capture].
4. Press [] or [] to select [Continuous].
5. Press [] to the [Capture Mode].