Lumens Technology PS400 - Manual (Page 14)

English - 13
Chapter 4 Installation
4.1 Setup the Digital Visualizer
1. Pull up the arm. The camera head should aim at the center of the
Visualizer.
2. Press and hold the Lamp release on both side of the Visualizer
and push the Lamp release outside to pull up the lamp.
3. Turning the camera head toward the platform according to the
direction of the arrows below.
※ Note：The angle of the camera head is limited. Don’t turn it
forcefully when it reaches the maximal angle.
4.2 Powering on the Digital Visualizer
※ Note：Before using the Digital Visualizer, make sure that you
have connected it to the computer, video source or other output
devices. See Figure: 3-2, Rear View for the position of connector
jack.
1. Press and open Digital Visualizer. The red LED
(blinks till finishing the initilization) will become green LED.
2.
Press on remote control to open light sources on both
sides or backlight source.
3. You can turn the lamp frame with suitable angle outside to get
better effect of illumination.
n
o
p