Louroe Electronics IF-PX User Manual
If-px, Introduction, Illustrated parts
Page 1 of 8
if-px inst 12/12
IF-PX
POE INTERFACE / POWER EXTRACTOR
INSTALLATION AND OPERATING INSTRUCTIONS
6955 VALJEAN AVE, VAN NUYS, CA 91406
PH: (818)994-6498 / FAX: (818)994-6458
/ www.louroe.com
®
LOUROE ELECTRONICS® 6 9 5 5 VA L J E A N AVENUE, VAN NUYS, CA 91406
TEL (818) 994-6498
FAX
994-6458
website: www.louroe.com e-mail: [email protected]
(818)
INTRODUCTION
FIG. 1
Model IF-PX is a single zone POE in-line interface designed to extracts power
from an Ethernet connection to power Louroe microphones, speaker/microphones
and external devices that require a 12Vdc supply such as Encoders and Non PoE
IP cameras. The IF-PX supports both one-way and two-way audio. Most
commercial grade line level unbalanced microphones are compatible with this
unit. Audio output has variable gain control.
Terminal blocks are employed to receive signal wiring from a Louroe Verifact
microphone or an AOP-SP speaker/microphone. Two 3.5mm stereo male to
3.5mm stereo male audio cables are included to connect the unit to an IP camera
or Encoder. Both Mode A and Mode B power options of IEEE802.3af are
supported. Outputs for both PoE (Power+Data) and Non-PoE (Data Only)
cameras and Encoders are included. The IF-PX has built-in thermal, overload and
short-circuit protection that protects the unit from overcurrent and over
temperature. The unit shuts down and turns back ON after the fault is removed.
ILLUSTRATED PARTS
1
2
3
4
5
6
7
8
9
10
Power+Data Output Jack
MIC Out Adjust
DC Out Terminal Block
DC IN Power Jack
Mic/Speaker Audio Terminal Block
Audio Input Jack
Data Out Only Jack
Power+Data Input Jack
Audio Output Jack
Power Indicator
Connects to PoE IP Cameras and/or Encoder
Adjust the audio output gain of the microphone
Receives 12Vdc power from external power supply (not supplied)
Receives wiring from Louroe Verifact Microphone and/or AOP-SP series
Connects to data input of Non-PoE IP Cameras, and Encoders.
Connects to PoE (802.3af) Switch or PoE (802.3af) Midspan
Lights Green indicating power is present to the unit
Connects to audio input of IP cameras,
Encoder, etc.
Provides audio to IP Cameras, Encoder, etc.
Receives audio from IP Camera, Encoder, etc. and connects to audio
output for talkback operation
Provides +12Vdc voltage to power external equipment such as
Non-PoE cameras, encoders, relays, etc.
FIG. 2
POE INTERFACE/POWER EXTRACT
OR
POWER + DATA
OUT
IEEE 802.3af
POE
MIC OUT
ADJUST
DC OUT
GND + 12V
DC IN
+12V
AUDIO
DATA OUT
P/N:LE-520
MIC/SPEAKER
OUT
IN
AUDIO
A B C SP
POWER + DA
TA
IN
1
2
3
4
5
6
7
8
9
10
REAR PANEL
FRONT PANEL