Louroe Electronics TLSP-CM - Manual (Page 2)

CONNECTING MODEL TLSP CORNER MOUNT TO A LOUROE BASE STATION
The following procedure pertains to all Louroe Base Stations with
talkback
After wiring connections are made at Model TLSP-CM, run recommended 4 conductor
cable to the Louroe Base Station and connect as follows. Connections are located on
rear panel of the base station.
RED wire (12Vdc) goes to terminal “A” of Base Station (zone 1, 2, etc)
BLACK wire (Audio Output) goes to terminal “B” of Base Station
BARE wire (ground) goes to terminal “C” of Base Station
GREEN speaker wire goes to “TB” (talkback) terminal of Base Station
WHITE speaker wire goes to “G” (ground) terminal of Base Station
TL
SP
-CM
Page 2 of 4
LOUROE ELECTRONICS 6 9 5 5 VA L J E A N AVENUE, VAN NUYS, CA 91406 TEL (818) 994-6498 FAX 994-6458
website: www.louroe.com e-mail: [email protected]
(818) ®
tlsp_cm_inst_3/15
INSTALLATION AND OPERATING INSTRUCTIONS
Material
Weight
Shipping Weight
10” L x 6” W x 4 1/2” D
Steel
2 lb 13 oz
4 lbs
SPECIFICATIONS (Speaker)
Power rating
Input
Frequency response
Voice coil impedance
7W
70.7V constant
300 Hz to 4 kHz
8
Speaker size 3”
Dimensions
Sensitivity -45 dBV/Pa
1 Pa = 94 dB SPL
Frequency Response 50 Hz to 15 kHz
Output Line Level (0 dBV, 600 W @ 1kHz)
Current Drain 10mA
Supply Voltage 12 Vdc
SPECIFICATIONS (MICROPHONE)