Louroe Electronics TLMC-W - Manual (Page 5)

INSTALLATION OF TLMC-W CALL STATION
Model TLMC-W is designed for mounting to a wall or flat surface. Included are two backboxes:
Lift and separate plastic backbox from metal backbox
1) SURFACE MOUNTING BACKBOX TO WALL
a. Metal backbox has 4 mounting holes for securing to wall
(screws not supplied).
b. Drill an opening at top, bottom, side or back of backbox for passing
wiring or connecting conduit.
c. Six small screws are supplied for attaching TLMC-W face plate to backbox.
2) FLUSH MOUNTING BACKBOX TO WALL
a. If plastic flush mount backbox is to be used:
b. Drill an opening at back side, as needed, to secure plastic backbox to proper position in wall
opening.
c. Drill an opening at a convenient location on backbox for passing wire or for conduit
connection (top, bottom, etc.)
d. Six plastic anchor bolts are supplied for securing TLMC-W face plate to backbox.
White plastic backbox is for flush mount
Beige metal backbox is for surface mount
(2) backboxes
plastic
backbox
metal
backbox
Page 5 of 8
LOUROE ELECTRONICS 6 9 5 5 VA L J E A N AVENUE, VAN NUYS, CA 91406 TEL (818) 994-6498 FAX 994-6458
website: www.louroe.com e-mail: [email protected]
(818) ®
INSTALLATION AND OPERATING INSTRUCTIONS
tlmc_w_inst_3/15