Louroe Electronics ASK-4 631 - Manual (Page 2)

WIRING REQUIREMENTS
2 conductor shielded, 22 gauge, with a 24 gauge drain wire.
West Penn 452 or equivalent
MICROPHONE INSTALLATION - MECHANICAL
Verifact A Microphone is designed for surface mounting to a ceiling or wall. Microphone will pick up
sounds 15’ away from all directions. For best results, install microphone as close to desired area of
coverage as possible. Avoid mounting microphone to ceiling heights in excess of 10’, or near air
vents, refrigeration units, or other audio interferences.
NOTE: Make wiring connection on back side of microphone before installing microphone to ceiling or
flat surface.
MICROPHONE INSTALLATION - ELECTRICAL
Located on back side of microphone is a terminal block marked A, B and C.
A is 12 Vdc
B is Audio
C is Ground (common)
Using recommended wiring, connect as follows:
RED wire to terminal A (12Vdc)
BLACK wire to terminal B (Audio)
BARE wire to terminal C
(Ground)
NOTE: If using wiring from other manufacturers,
color code may vary.
12 Vdc Power Jack
Microphone Input Terminal Block
Audio Out Control
(Gain Adjustment)
RCA Audio Out Jack
3.5mm Stereo Audio Out Jack
LOUROE MODEL IF-1 AUDIO INTERFACE ADAPTER
INSTALLATION AND OPERATING INSTRUCTIONS
Page 2 of 8
LOUROE ELECTRONICS 6 9 5 5 VA L J E A N AVENUE, VAN NUYS, CA 91406 TEL (818) 994-6498 FAX 994-6458
website: www.louroe.com e-mail: [email protected]
(818) ®
MS-1 MECHANICAL INSTALLATION
The MS-1 (Mute Switch) fits in a single gang electrical box for flush or surface mounting to a wall.
Electrical connection is thru a 3 Pin Terminal block.
Ask4_631_inst_2/15
®