Louroe Electronics ASK-4 501 TLI-CF - Manual (Page 4)

WIRING CONNECTIONS BETWEEN MODEL TLI-CF SPEAKER/MICROPHONE AND AP-1TB
AUDIO BASE STATION
1) Connect one end of recommended cable to remote speaker/microphone (TLI-CF) as shown in Fig. 3. Connect wires
wrapped with overall shield to terminals “A”, “B”, and “C” of TLI-CF’s terminal block. When using sample cable,
connect red wire to terminal “A”; black wire to terminal “B” and bare wire to terminal “C”.
2) Connect the two speaker wires (twisted pair) green and white to green and white wires of TLI-CF’s 70V transformer.
Using wire nut connect green wire to green wire of TLI-CF’s 70V Transformer. Again, using wire nut connect white
wire to white wire of TLI-CF’s 70V Transformer.
3) Connect the other end of the cable to AP-1TB Mic 6-Pin Terminal Block [12]. Make sure that wire connected to
terminal “A” of remote TLI-CF connects to terminal “A” of AP-1TB’s Mic 6-Pin Terminal Block [12]; wire connected to
terminal “B” of TLI-CF connects to terminal “B” of AP-1TB; “C” to “C”. Observe cable color coding. Terminal “P” of AP-
1TB is not used with this application. Used only when paralleling to a second AP-1TB.
4) For speaker connection, connect green speaker wire (positive) to Mic 6-Pin Terminal Block [12] terminal “SP”,
connect white speaker wire (ground) to “G”.
5) When a recording device is used (DVR,VCR,etc.) connect Audio-OUT Jack [11] to recorder’s Audio-IN Jack with the
dual RCA cable (supplied).
6) Connect Audio-IN Jack [10] to recorder’s Audio-OUT Jack with the remaining RCA plug.
INSTALLATION AND OPERATING INSTRUCTIONS
Page 4 of 8
LOUROE ELECTRONICS 6 9 5 5 VA L J E A N AVENUE, VAN NUYS, CA 91406 TEL (818) 994-6498 FAX 994-6458
website: www.louroe.com e-mail: [email protected]
(818) ®
MECHANICAL INSTALLATION OF TLI-CF SPEAKER/MICROPHONE
See Fig. 4 and 5
Ask4_501-TLI-CF_inst_2/15