Louroe Electronics ASK-4 431 - Manual (Page 2)

WIRING REQUIREMENTS
2 conductor shielded, 22 gauge, with a 24 gauge drain wire.
West Penn 452 or equivalent
MICROPHONE INSTALLATION - MECHANICAL - MICROPHONE
Model A Microphone is designed for surface mounting to a ceiling or wall. Microphone will pick up sounds 15’ away from
all directions. For best results, install microphone as close to desired area of coverage as possible. Avoid mounting
microphone to ceiling heights in excess of 10’, or near air vents, refrigeration units, or other audio interferences.
NOTE: Make wiring connection on back side of microphone before installing microphone to ceiling or flat surface.
MICROPHONE INSTALLATION - ELECTRICAL
Located on back side of microphone is a terminal block marked A, B and C.
A is 12 Vdc
B is Audio
C is Ground (common)
Using recommended wiring, connect as follows:
RED wire to terminal A (12Vdc)
BLACK wire to terminal B
(Audio)
BARE wire to terminal C (Ground)
NOTE: If using wiring from other manufacturers,
color code may vary.
12 Vdc Power Jack
Microphone Input Terminal Block
Audio Out Control
(Gain Adjustment)
RCA Audio Out Jack
3.5mm Stereo Audio Out Jack
MODEL IF-1 AUDIO INTERFACE ADAPTER
INSTALLATION AND OPERATING INSTRUCTIONS
Page 2 of 8
LOUROE ELECTRONICS® 6955 VALJEAN AVENUE, VAN NUYS, CA 91406 TEL (818) 994-6498 FAX 994-6458
website: www.louroe.com e-mail: [email protected]
(818)
MECHANICAL - RN-2 AND IF-1
RN-2 and IF-1 can be installed to a wall or flat surface with mounting screws or by using a strong double backed adhesive
tape. They are usually located between the microphones and the receiving device such as a DVR or IP Camera
.
WIRING CONNECTION FROM MICROPHONES TO RN-2
1) Bring in wiring from first Louroe microphone (or speaker/microphone) to INPUT side of RN-2 and connect as
follows:
1. Wire from terminal A of microphone goes to A of RN-2
2. Wire from terminal B of microphone goes to B1 of RN-2
3. Wire from terminal C of microphone goes to C of RN-2
2) Bring in wiring from second microphone (or speaker/microphone) to INPUT side of RN-2 and connect as follows::
1. Wire from terminal A of second microphone goes to A of RN-2
2. Wire from terminal B of second microphone goes to B2 of RN-2
3. Wire from terminal C of second microphone goes to C of RN-2
ask4_431_inst_2/15