Louroe Electronics LE-575 - Manual (Page 3)

MICROPHONE GAIN ADJUSTMENT
The microphone has an audio output
gain potentiometer. Microphone is
always shipped with a 0dB output. If
it’s necessary to change the gain of
the microphone, insert a small
screwdriver into the potentiometer
rotate clockwise to increase or
counterclockwise to decrease.
Maximum gain is +10dB
INSTALLATION AND OPERATING INSTRUCTIONS
Page 3 of 4
LOUROE ELECTRONICS 6 9 5 5 VA L J E A N AVENUE, VAN NUYS, CA 91406 TEL (818) 994-6498 FAX 994-6458
website: www.louroe.com e-mail: [email protected]
(818) ®
2 Conductor shielded cable, 22
gauge with a 24 gauge drain
wire.
NOTE: Unshielded cable is not
satisfactory for audio
systems.
WIRING REQUIREMENTS
PLUGGABLE CONNECTOR
PLUGGABLE HEADER
MIC ELEMENT
TO LOUROE BASE STATION, AUDIO INTERFACE
OR OTHER RECEIVING DEVICES
A
B
C
Egc_mic-inst_12/14