Louroe Electronics LE-569 - Manual (Page 3)

TO LOUROE BASE STATION
OR
TO OTHER LOUROE AUDIO INTERFACE DEVICES
(IF-1, IF-2, IF-4, IF-8 ETC.)
INSTALLATION AND OPERATING INSTRUCTIONS
Page 3 of 4
LOUROE ELECTRONICS 6 9 5 5 VA L J E A N AVENUE, VAN NUYS, CA 91406 TEL (818) 994-6498 FAX 994-6458
website: www.louroe.com e-mail: [email protected]
(818) ®
C B A
BARE
BLACK
RED
A B C
BLACK
BARE
RED
A = +12Vdc (RED)
B = Audio (BLACK)
C = Ground (BARE)
2 Conductor shielded cable, 22
gauge with a 24 gauge drain
wire.
NOTE: Unshielded cable is not
satisfactory for audio
systems.
WIRING REQUIREMENTS
MICROPHONE GAIN ADJUSTMENT
The microphone has an audio output gain potentiometer.
Microphone is always shipped with a 0dB output. If it’s necessary
to change the gain of the microphone, insert a small screwdriver
into the potentiometer rotate clockwise to increase or
counterclockwise to decrease. Maximum gain is +10dB
DVgc_mic-inst_12/14