Leprecon LPC Quick Start guide RevF - Manual (Page 10)

10
If there are channels selected when the ‘group’ button is pressed, that selection will be
carried into the ‘group’ creation screen. Channels can be selected and de-selected from
the group screen as well.
Once channels are selected, click or touch ‘save as’ to create the new group. Give the
group a convenient name, and it can be re-used for future recording.
4.6. Bump buttons
LPC bump buttons are used to flash a channel or submaster to full level. There are four
modes of bump operation, controlled by the front panel 'bump' key.
Off - bumps are disabled.
Add - pressing a bump button brings up a channel or submaster without affecting other
channels.
Solo - pressing a bump button brings up a single channel or sub, and blacks out all other
channels.
Toggle - pressing and releasing a bump turns on a channel or sub. Pressing the bump a
second time turns off the channel or sub.
Note: When a submaster is turned on with toggle mode, it will fade up and down using
Submaster fade times.