Lencore Spectra Classic: Installation and Operations Manual - Manual (Page 13)

materials required
common questions
Cable shall be 18 gauge,Stranded ,UL Listed, Plenum Rated,
non shielded.
Transformer shall be UL 1411 Listed with an output of 16/18volts.
Fuse shall be UL Listed 3.0 amps installed at each 40va transformer, 125 volts (Max)
rating. Fuse holder shall be UL Listed with same rating. Not required for installations
using 95v a transformers due to built-in circuit breaker.
Wire nuts & caddy clips.
OPTIONAL EQUIPMENT
Ramset or Hilti Gun (for deck installation)
Telescopic Pole (15’ extension)
1
2
3
4
NOTE
Estimate approximately 20’of wire per unit,allowing additional footage for home runs to
transformers and/or other equipment such as CVC’s,Timers, Amplifiers, etc.
Wire can be purchased in full rolls of 1,000 feet. Standard layouts will require that two-
thirds of wire purchased be 2-conductor and the balance of wire pur chased can be two,
four, or six conductor depending on applications used.
CONTROLS TO ADJUST THE MAIN (MASTER) UNIT.
PHOTO SHOWS BOTTOM OF UNIT.
11