DeLonghi D28313 - Manual (Page 8)

DESCRIPTION OF THE APPLIANCE
(see diagram pag. 3)
A.
Basket handle
B. Handle slide
C. Lid
D. Viewing window
E. Filter cover
F. Basket
G. Filter cover hook
H. Cable holder compartment
I. Handle for lifting up the appliance
J. Drainage pipe plug
K. Foot
L. Oil drainage pipe
M. Signal lamp
N. Thermostat
O. Inspection door for pipe compartment
P. Opening button
Q. Minute timer display (some models only)
R. Minute timer button (some models only)
INSTRUCTIONS FOR USE
Filling with oil or fat
• Raise the basket (F) to the highest position by pul-
ling the special “A” handle upwards (fig.1).
The lid should ALWAYS be closed when the basket
is raised and lowered.
• Open lid “C” by pressing button “P” (fig.2).
• Remove the basket by pulling it upwards (fig.3).
• Pour into the container 1.2 litres of oil (or 1 kg. of
fat).
WARNING: The level must always be between the
maximum and minimum levels indicated.
Never use the deep fryer when the oil is below the
“min” level as it could cause the thermal safety devi-
ce to come into operation; to replace it you need to
contact one of our service centres
.
Best results are obtained by using a good peanut oil.
Avoid mixing different types of oil. If you use lumps of
solid fat, cut them into small pieces so that the deep
fryer does not heat up in the first few minutes without a
covering of fat. The temperature must be set to
300 °F
until the fat has melted completely. The required tempe-
rature can then be set.
STARTING TO FRY
1. Put the food which is to be fried into the basket,
without ever overfilling it (max. 1 kg. of fresh pota-
toes).
In order to obtain a more even frying, we recom-
mend concentrating the food especially around the
perimeter of the basket., leaving the central part
more sparingly filled.
2. Put the basket into the boiler pan in a raised posi-
tion (fig.3) and close the lid by pressing lightly
down upon it until the hooks click. Always close the
7
A DEEP FRYER FALLING FROM A HIGH PLACE MAY
CAUSE SERIOUS BURNS. NEVER LEAVE THE CORD
HANGING FROM THE EDGE OF THE SURFACE THE
DEEP FRYER IS RESTING ON WHERE IT COULD BE
GRASPED BY A CHILD OR GET IN THE WAY OF THE
USER. DO NOT USE EXTENSION CORDS.
IMPORTANT SAFEGUARD
KEEP OUT OF REACH OF CHILDREN
IF THE DEEP FRYER HAS A CORD WITH MAGNETIC CONNECTOR
First, connect the magnetic connector to the appliance
as shown in figure 17, making sure the protruding part
of the connector (X) is correctly inserted into the corre-
sponding outlet on the appliance. Then plug the cord
into the outlet.
Warning
Never leave the appliance plugged into the outlet if the
magnetic connector is not fitted to the deep fryer, figu- re 18. If the magnetic connector does not remain in
place, check that it has been inserted correctly, (see
figure 17). If the problem persists, contact an authori-
zed service center. When the appliance is in operation,
always leave free space around the magnetic connec-
tor to prevent it from becoming detached. Only use a
type TA-35PA or LT-512 cord set supplied by De'Lon-
ghi authorised service centres.