Dolby Laboratories CP65 - Manual (Page 24)

3-1
SECTION 3
AN OVERVIEW OF THE ALIGNMENT PROCEDURE
This section is an overview of the general principles involved in the alignment of Dolby
cinema equipment. It is useful to develop an understanding of why the CP65 is aligned
as described in this manual. If the installer is already familiar with these principles, or
is in a hurry to complete the installation, this section may be read later. Continue the
installation procedure beginning with Section 4.
1. Aligning the A-Chain
The A-Chain is first calibrated by use of the Cat. No. 69 Dolby Tone test film to establish the
correct Dolby operating level within the CP65 and to ensure correct tracking of the Dolby noise
reduction circuit.
Pink noise is used for equalization of the A-chain. (Pink noise is similar to white noise but
provides equal energy per octave of bandwidth.) Pink noise for A-chain alignment is recorded
on the other side of the Cat. No. 69 test film. The output should be displayed on a Real Time
Analyzer (RTA) so adjustments can be made quickly.
The optical slit is the key element in the A-chain because it imposes the initial limitation on the
high-frequency response of the system. Light from the exciter lamp passes through the optical
slit and is focussed on the optical soundtracks on the film. The light that passes through the
soundtracks falls on the stereo solar cell which generates an electrical signal that is
proportional to the audio signal recorded on the optical soundtracks. The slit introduces high
frequency loss which must be compensated by circuitry in the Cat. No. 240A optical
preamplifier (see Appendix B).
The slit image must be correctly focussed on the film and must be precisely at right angles to
the direction of film movement in order to maintain the correct phase relationships between
the two optical tracks. Any azimuth error will show as a loss of high frequency in the front
channels and potentially excessive crosstalk in the surround channels.
Each channel in the Cat. No. 240A optical preamplifier is equipped with a slit loss equalizer
control. Adjustment of this control shifts a fixed amount of boost upward or downward in
frequency, but the shape of the curve remains constant. A perfectly flat response up to a
minimum of 12 kHz can be achieved possible. See Appendix B for further details.
2. Aligning the B-Chain
In most theatre playback systems, the acoustical qualities of the theatre are difficult to
change. Therefore, the primary area where improvement is possible is correcting
loudspeaker response errors caused by the theatre acoustic environment.
It is not practical for the entire cinema industry to standardize on a single make and model of
loudspeaker. In any event, the different acoustical characteristics of individual theatres
would, to some extent, negate any such standardized speakers. Electronic equalization of
each loudspeaker system achieves consistent results in a broad spectrum of environments,