Laminator Direct VALUE-LAM 4500HC - 2 Roller - Manual (Page 12)

12
5. Turn the MOTOR switch ON and perform a test mount to ensure proper settings for
successful mounting. If any adjustments are necessary make them now and run another
test. Repeat this step until you obtain desired results.
6. Position the print to be mounted on a section of mount board up to1/2” thick behind a
leader board. The leader board will prevent compression of the leading edge of your mount
board.
7. Peel the release liner from the board back about ¼” behind a leader board if necessary
unless your mount board is larger than your print and you will be trimming your board
afterwards. A leader board will prevent compression on the leading edge of your mount
board.
8. Feed the print and mount board into the laminator behind the leader board slowly and
evenly. Be sure to pull back the release liner before it enters the rollers.
9. You may mount subsequent prints now, one directly behind the other so that the board in
front becomes the leader board.
10. Once your last print has completely exited the laminator, turn the MOTOR switch OFF
and use a razor to remove the mounted and laminated prints.
11. If using thermal mount boards add about 20° or decrease speed to allow heat to
penetrate your print and activate adhesive (Please see step 7, page ).
Maintenance/Service...
Always use caution when servicing your laminator.
Precautions:
Disconnect the power supply and open the panel breaker
before attempting to service or repair the laminator.
Any maintenance or service should be preformed only by those
having appropriate technical training and experience.
Adjust only those controls that are specified in these
operating instructions.