Lacava 1583 - Manual (Page 5)

LACAVA LLC 5
5. Place the spout through its faucet hole and from below
the mounting surface, slide the rubber pad and metal
mounting support onto the mounting post.
6. Screw the locking nut onto the mounting screw by hand
until tight, then turn an additional ¼ turn using a wrench.
Be careful not to overtighten the nut, as this may cause
damage to the mounting surface.
8. Attach the vertical pop-up control rod to the connector
by sliding it through its designated hole and tightening
the screw to keep it in place.
9. Remove the gray plastic cap from the drain body and
then place the horizontal control rod into the opening so
that the plastic ball and gasket fit inside. Then slide the
plastic cap over the rod and tighten back into place.
10. Attach the horizontal control rod to the appropriate
height on the connector.
11. Connect a water line from each handle to the brass T-
connector at the base of the spout.
12. Connect both handles to the hot & cold water supply
with the provided flexible supply lines.