Lacava 1583 - Manual (Page 4)

LACAVA LLC 4
Installation Instructions/Instrucciones de Instalación
1. Place the cartridge bodies up through their designated
holes. Then place a handle base onto each extension
and thread onto the brass body, making sure a rubber
o-ring sits in its groove at the bottom of each handle
base.
2. Tighten each locking nut upwards as far as possible.
Make sure not to overtighten, as this can potentially
cause damange to the mounting surface.
3. Push a cross handle on to each cartridge extension and
tighten the set screw to keep in place.
4. Remove the mounting hardware from the spout assembly.
5. Unscrew the handle from the vertical pop-up control rod
and then slide the rod through the slot on the back of
the mixer body from below. Then screw the handle back
into place.