Lacava 1432 - Manual (Page 5)

LACAVA LLC 5
4. Remove all of the mounting hardware from the spout
mounting post and shower socket.
5. Place the spout & shower socket through their respective
holes and from below the mounting surface, slide
the rubber pad and metal mounting support onto each.
6. Screw the locking nut onto the spout & shower socket by
hand until tight, then turn an additional ¼ turn using a
wrench. Be careful not to overtighten the nuts, as this
may cause damage to the mounting surface.
7. Slide the shower hose through the socket and connect to
the bottom of the diverter valve.
8. Connect the hand-held shower to the shower hose and
then place the assembly into the shower socket.
9. Connect a water line from each control handle to the
diverter valve and then connect the hot and cold
supply lines to designated control valve.
10. If desired, place a small bead of silicone around outside
edge of each escutcheon.
11. Turn on the water supply and check for any leaks.