Lacava 0475 - Manual (Page 6)

LACAVA LLC 6
11. Connect the internal water lines to the mixer body.
12. Place the faucet onto the rough-in assembly, making
sure the water lines push into the inlets smoothly.
13. Tighten into place by tightening the brass locking nut
by using the provided Allen wrench to spin.
14. Press the escutcheon down until it is flush with the
finished floor.
15. Connect one end of the shower hose to the water
intake located on the bottom of the spout. Remove
the aerator assembly from the end of the spout.
16. Make sure the faucet is in the off position and then turn
on the water supply. Check for any leaks and repair if
necessary.
17. Place the open end of the shower hose into the tub
and make sure spout is pointed over tub as well. Turn
on the fixture and let the water run for about 2-3
minutes.
18. Reattach the aerator assembly back onto the spout.
19. Attach the open end of the shower hose to the hand-
held shower head and rest the shower head onto its
hook.
20. Place a bead of silicone around the escutcheon to
create a watertight seal.