Lacava 1495 - Manual (Page 6)

LACAVA LLC 6
12. Connect the internal water lines to the mixer body.
13. Lubricate the o-rings and slide the water lines into the
rough-in outlets without damaging the o-rings.
14. Tighten into place by tightening the brass locking nut.
Use the provided Allen wrench in the hole for leverage.
15. Slide the escutcheon down until it is flush with the
finished floor.
16. Lubricate the o-rings and then slide the spout into
position on the floor extension and secure into place by
tightening the set screw.
17. Connect one end of the shower hose to the water
intake located on the bottom of the spout.
18. Make sure the faucet is in the off position and then turn
on the water supply. Check for any leaks and repair if
necessary.
19. Place the open end of the shower hose into the tub
and make sure spout is pointed over tub as well. Turn
on the fixture and let the water run for about 2-3
minutes through each function.
20. Attach the open end of the shower hose to the hand-
held shower head and rest the shower head onto its
hook.
21. Place a bead of silicone around the escutcheon to
create a watertight seal.