La Crosse Technology WS-9250U-IT - Manual (Page 5)

5
POSITIONING THE TEMPERATURE TRANSMITTER:
The temperature transmitter can be placed on any flat surface or wall mount using the bracket which
doubles as a stand or wall mount base.
To wall mount:
1.
Secure the bracket onto a desired wall using the screws and plastic anchors.
2. Clip the transmitter onto the bracket.
Note:
Before permanently fixing the transmitter wall base, place all units in the desired locations to check that the
outdoor temperature reading is receivable. In event that the signal is not received, relocate the units or
move them slightly as this may help the signal reception.
CARE AND MAINTENANCE:
x
Extreme temperatures, vibration and shock should be avoided as these may cause damage to the unit and give
inaccurate forecasts and readings.
x When cleaning the display and casings, use a soft damp cloth only. Do not use solvents or scouring agents as
they may mark the LCD and casings.
x Do not submerge the unit in water.
x Immediately remove all low powered batteries to avoid leakage and damage. Replace only with new batteries of
the recommended type.
x Do not make any repair attempts to the unit. Return them to their original point of purchase for repair by a
qualified engineer. Opening and tampering with the unit may invalidate their guarantee.
x Do not expose the units to extreme and sudden temperature changes, this may lead to rapid changes in
forecasts and readings and thereby reduce their accuracy.
SPECIFICATIONS
Temperature measuring range:
Indoor
: 14.1ºF to 139.8ºF with 0.2ºF resolution ( “OF.L” displayed if outside this range)
Outdoor : -39.8ºF to +139.8ºF with 0.2ºF resolution ( “OF.L” displayed if outside this range)
Indoor temperature checking interval : every 16 seconds
Outdoor temperature reception : every 4 seconds
Transmission range : up to 330 feet / 100 meters (open space)
Power consumption:
Weather station
: 2 x AA, IEC, LR6, 1.5V
Battery life cycle : Approx. 12 months (Alkaline batteries recommended)
Temperature transmitter
: 2 x AAA, IEC, LR3, 1.5V
Battery life cycle : Approx. 12 months (Alkaline batteries recommended)
Dimensions (L x W x H)
Weather station
: 5.46” x 0.95” x 3.91” / 138.8 x 24.3 x 99.5 mm
Temperature transmitter : 1.41” x 0.62” x 4.03” / 36 x 16 x 102.6 mm
(wall bracket excluded)
WARRANTY INFORMATION
La Crosse Technology, Ltd provides a 1-year limited warranty on this product against manufacturing defects in
materials and workmanship.
This limited warranty begins on the original date of purchase, is valid only on products purchased and used in North
America and only to the original purchaser of this product. To receive warranty service, the purchaser must contact La
Crosse Technology, Ltd for problem determination and service procedures. Warranty service can only be performed
by a La Crosse Technology, Ltd authorized service center. The original dated bill of sale must be presented upon
request as proof of purchase to La Crosse Technology, Ltd or La Crosse Technology, Ltd’s authorized service center.
La Crosse Technology, Ltd will repair or replace this product, at our option and at no charge as stipulated herein, with
new or reconditioned parts or products if found to be defective during the limited warranty period specified above. All
replaced parts and products become the property of La Crosse Technology, Ltd and must be returned to La Crosse
Technology, Ltd.
Replacement parts and products assume the remaining original warranty, or ninety (90) days, whichever is longer. La
Crosse Technology, Ltd will pay all expenses for labor and materials for all repairs covered by this warranty. If
necessary repairs are not covered by this warranty, or if a product is examined which is not in need or repair, you will
be charged for the repairs or examination.
The owner must pay any shipping charges incurred in getting your La Crosse Technology, Ltd product to a La Crosse
Technology, Ltd authorized service center.
Your La Crosse Technology, Ltd warranty covers all defects in material and workmanship with the following specified
exceptions: (1) damage caused by accident, unreasonable use or neglect (including the lack of reasonable and
necessary maintenance); (2) damage occurring during shipment (claims must be presented to the carrier); (3) damage
to, or deterioration of, any accessory or decorative surface; (4) damage resulting from failure to follow instructions
contained in your owner’s manual; (5) damage resulting from the performance of repairs or alterations by someone
other than an authorized La Crosse Technology, Ltd authorized service center; (6) units used for other than home use
(7) applications and uses that this product was not intended or (8) the products inability to receive a signal due to any
source of interference.
This warranty covers only actual defects within the product itself, and does not cover the cost of installation or removal
from a fixed installation, normal set-up or adjustments, claims based on misrepresentation by the seller or performance
variations resulting from installation-related circumstances.
LA CROSSE TECHNOLOGY, LTD WILL NOT ASSUME LIABILITY FOR INCIDENTAL, CONSEQUENTIAL,
PUNITIVE, OR OTHER SIMILAR DAMAGES ASSOCIATED WITH THE OPERATION OR MALFUNCTION OF THIS
PRODUCT. THIS PRODUCT IS NOT TO BE USED FOR MEDICAL PURPOSES OR FOR PUBLIC INFORMATION.
THIS PRODUCT IS NOT A TOY. KEEP OUT OF CHILDREN’S REACH.
This warranty gives you specific legal rights. You may also have other rights specific to your State. Some States do no
allow the exclusion of consequential or incidental damages therefore the above exclusion of limitation may not apply to
you.
Contact info for warranty or technical support:
La Crosse Technology
2817 Losey Blvd. S.
La Crosse, WI 54601
Product Info and Support: Product Registration:
www.lacrossetechnology.com/9250 www.lacrossetechnology.com/support/register.php
Contact Support: 1-608-782-1610
All rights reserved. This handbook must not be reproduced in any form, even in excerpts, or duplicated or processed using
electronic, mechanical or chemical procedures without written permission of the publisher.
This handbook may contain mistakes and printing errors. The information in this handbook is regularly checked and corrections
made in the next issue. We accept no liability for technical mistakes or printing errors, or their consequences.
All trademarks and patents are acknowledged.
FCC ID: OMO-M-15 (transmitter)
FCC DISCLAIMER
RF Exposure mobile:
The internal / external antennas used for this mobile transmitter must provide a separation distance of at least 20 cm (8
inches) from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter."
Statement according to FCC part 15.19:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
Statement according to FCC part 15.21: