La Crosse Technology WS-9133 User Manual
Page 2
5
light up briefly. Following the time as 12:00 and the weather icon will be
displayed. If these are not displayed after 60 seconds, remove the
batteries and wait for at least 10 seconds before reinserting them.
3.
After inserting the batteries, the Weather station will start receiving data
from the transmitter. The outdoor temperature and the signal reception
icon should then be displayed on the Weather station. If this does not
happen after 3 minutes, the batteries will need to be removed from both
units and reset from step 1.
4.
In order to ensure sufficient 915 MHz transmission however, this should
under good conditions be a distance no more than 100 meters (330
feet) between the final position of the Weather Station and the
transmitter (see notes on “Mounting” and “915 MHz Reception”).
HOW TO INSTALL AND REPLACE BATTERIES IN THE TEMPERATURE
STATION
The Weather Station uses 3 x AA, IEC LR6, 1.5V batteries. When batteries
will need to be replaced, the
low battery icon will appear on
the LCD. To install and replace
the batteries, please follow the
steps below:
1.
Lift up the battery
compartment cover.
2. Insert
batteries
observing
the correct polarity (see
marking).
3. Replace
compartment
cover.
6
HOW TO INSTALL AND REPLACE BATTERIES IN THE TEMPERATURE
TRANSMITTER
The Temperature Transmitter uses 2 x AA, IEC LR6,
1.5V battery. To install and replace the batteries,
please follow the steps below:
1.
Remove the battery compartment cover at the
back of the transmitter.
2.
Insert the batteries, observing the correct polarity
(see marking).
3.
Replace the battery compartment cover on the
unit.
Note:
In the event of changing batteries in any of the units, all units need to be reset
by following the setting up procedures. This is because a security code is
assigned by the transmitter at start-up and this code must be received and
stored by the Weather station in the first 3 minutes of power being supplied to
it.
BATTERY CHANGE:
It is recommended to replace the batteries in all units regularly to ensure
optimum accuracy of these units (Battery life See Specifications below).
Please participate in the preservation of the environment.
Return used batteries to an authorized depot.
FUNCTION KEYS:
Weather station:
The weather station has four easy to use function keys.
7
SET key
Press the key to enter manual setting modes: time, 12/24 hour time
display, and temperature unit (ºC/ºF) setting
Stop the alarm
+ key
To make adjustment for various settings
Stop the alarm
ALARM key
Enter the alarm setting mode
Switch the alarm ON/ OFF
Stop the alarm
MIN/MAX RESET key
Press and hold to reset the MIN/MAX temperature records
Activate the snooze
Exit manual setting modes
SET key
MIN/MAX RESET key
ALARM key
+ key
8
Outdoor
Reception
Signal icon*
MIN/MAX indoor
temperature
MIN/MAX outdoor
temperature
LCD SCREEN AND SETTINGS:
* When the outdoor signal is successfully received by the Weather Station,
this icon will be switched on. (If not successful, the icon will not be shown in
LCD) So user can easily see whether the last reception was successful (icon
on) or not (icon off).
For a better display clarity, the LCD screen is split into 3 sections.
Section 1 - TIME AND ALARM
Display of time
Time
Indoor
Temperature
in °C/ °F
Outdoor
Temperature
in °C/ °F
Weather
tendency
indicator
Weather
forecast icon
Low battery
indicator
(weather
station)
Low battery
indicator
(transmitter)
Alarm icon